MAX 10 FPGA Development Kit User Guide

Download PDF
ID 683460
Date 9/07/2017
Public
Document Table of Contents
Document Table of Contents x
1. Overview 2. Getting Started 3. Board Test System 4. Board Components A. Additional Information
1. Overview x
1.1. General Description 1.2. Handling the Board
2. Getting Started x
2.1. Quartus II Web Edition Software 2.2. Installing the Development Kit 2.3. Installing the USB-Blaster Driver 2.4. Board Update Portal
3. Board Test System x
3.1. Using the Configure Menu 3.2. The System Info Tab 3.3. The GPIO Tab 3.4. The Flash Tab 3.5. The HSMC Tab 3.6. The DDR3 Tab 3.7. The ADC Tab 3.8. The HDMI Tab 3.9. The Sleep Mode Tab 3.10. The Power Monitor 3.11. The Clock Control
4. Board Components x
4.1. Board Overview 4.2. Featured Device 4.3. Configuration 4.4. Status Elements 4.5. Setup Elements 4.6. General User Input/Output 4.7. Clock Circuitry 4.8. Components and Interfaces 4.9. Memory 4.10. Power Distribution System
4.3. Configuration x
4.3.1. Using the Quartus II Programmer 4.3.2. Selecting the Internal Configuration Scheme 4.3.3. Switch and Jumper Settings
4.7. Clock Circuitry x
4.7.1. On-Board Oscillators 4.7.2. Off-Board Clock Input/Output
4.8. Components and Interfaces x
4.8.1. 10/100/1000 Ethernet PHY 4.8.2. Digital-to-Analog Converter 4.8.3. HDMI Video Output 4.8.4. HSMC 4.8.5. Pmod Connectors 4.8.6. USB to UART
4.9. Memory x
4.9.1. DDR3 Rev. B Board 4.9.2. DDR3 Rev. C Board 4.9.3. Flash
A. Additional Information x
A.1. User Guide Revision History A.2. Compliance and Conformity Statements
A.2. Compliance and Conformity Statements x
A.2.1. CE EMI Conformity Caution
1. Overview
2. Getting Started
3. Board Test System
4. Board Components
A. Additional Information

3.1. Using the Configure Menu

Use the Configure menu to select the design you want to use. Each design example tests different board features. Choose a design from this menu and the corresponding tabs become active for testing.
Figure 6. The Configure Menu

To configure the FPGA with a test system design, perform the following steps:

  1. On the Configure menu, click the configure command that corresponds to the functionality you wish to test.
  2. In the dialog box that appears, click Configure to download the corresponding design to the FPGA.
  3. When configuration finishes, close the Quartus II Programmer if open. The design begins running in the FPGA. The corresponding GUI application tabs that interface with the design are now enabled.
If you use the Quartus II Programmer for configuration, rather than the Board Test System GUI, you may need to restart the GUI.
Level Two Title