MAX 10 FPGA Development Kit User Guide

Download PDF
ID 683460
Date 9/07/2017
Public
Document Table of Contents
Document Table of Contents x
1. Overview 2. Getting Started 3. Board Test System 4. Board Components A. Additional Information
1. Overview x
1.1. General Description 1.2. Handling the Board
2. Getting Started x
2.1. Quartus II Web Edition Software 2.2. Installing the Development Kit 2.3. Installing the USB-Blaster Driver 2.4. Board Update Portal
3. Board Test System x
3.1. Using the Configure Menu 3.2. The System Info Tab 3.3. The GPIO Tab 3.4. The Flash Tab 3.5. The HSMC Tab 3.6. The DDR3 Tab 3.7. The ADC Tab 3.8. The HDMI Tab 3.9. The Sleep Mode Tab 3.10. The Power Monitor 3.11. The Clock Control
4. Board Components x
4.1. Board Overview 4.2. Featured Device 4.3. Configuration 4.4. Status Elements 4.5. Setup Elements 4.6. General User Input/Output 4.7. Clock Circuitry 4.8. Components and Interfaces 4.9. Memory 4.10. Power Distribution System
4.3. Configuration x
4.3.1. Using the Quartus II Programmer 4.3.2. Selecting the Internal Configuration Scheme 4.3.3. Switch and Jumper Settings
4.7. Clock Circuitry x
4.7.1. On-Board Oscillators 4.7.2. Off-Board Clock Input/Output
4.8. Components and Interfaces x
4.8.1. 10/100/1000 Ethernet PHY 4.8.2. Digital-to-Analog Converter 4.8.3. HDMI Video Output 4.8.4. HSMC 4.8.5. Pmod Connectors 4.8.6. USB to UART
4.9. Memory x
4.9.1. DDR3 Rev. B Board 4.9.2. DDR3 Rev. C Board 4.9.3. Flash
A. Additional Information x
A.1. User Guide Revision History A.2. Compliance and Conformity Statements
A.2. Compliance and Conformity Statements x
A.2.1. CE EMI Conformity Caution
1. Overview
2. Getting Started
3. Board Test System
4. Board Components
A. Additional Information

4.3. Configuration

The MAX 10 FPGA development kit supports two configuration methods:
  • Configuration by downloading a .sof file to the FPGA. Any power cycling of the FPGA or reconfiguration will power up the FPGA to a blank state.
  • Programming of the on-die FPGA Configuration Flash Memory (CFM) via a .pof file. Any power cycling of the FPGA or reconfiguration will power up the FPGA in self-configuration mode, using the files stored in the CFM.
You can use two different USB-Blaster™ hardware components to program the .sof or .pof files:
  • Embedded USB-Blaster II, type-B connector (J12).
  • JTAG header (J14). Use an external USB-Blaster, USB-Blaster II, or Ethernet Blaster download cable. The external download cable connects to the board through the JTAG header (J14).

Section Content
Using the Quartus II Programmer
Selecting the Internal Configuration Scheme
Switch and Jumper Settings

Level Two Title