Ethernet Design Example Components User Guide

Download PDF
ID 683044
Date 4/01/2024
Public
Document Table of Contents
Document Table of Contents x
1. Time-of-day Clock 2. Time-of-day Synchronizer 3. Packet Classifier 4. Ethernet Design Example Components User Guide Archives 5. Document Revision History for the Ethernet Design Example Components User Guide
1. Time-of-day Clock x
1.1. Release Information 1.2. Resource Utilization 1.3. Configuring the TOD Clock 1.4. Using the TOD Clock 1.5. Interface Signals 1.6. Configuration Registers
1.1. Release Information x
1.1.1. Pulse Per Second Device Speed Grade Support
1.4. Using the TOD Clock x
1.4.1. Adjusting TOD Drift 1.4.2. Adjusting Offset, Jitter, and Wander 1.4.3. Correcting TOD Offset 1.4.4. IOPLL and TOD Setup for Pulse Per Second (Advanced Accuracy Mode)
1.4.4. IOPLL and TOD Setup for Pulse Per Second (Advanced Accuracy Mode) x
1.4.4.1. IOPLL and TOD Setup using Dynamic Phase Shift Interface 1.4.4.2. IOPLL and TOD Setup using IOPLL Reconfig IP
1.5. Interface Signals x
1.5.1. Avalon Memory-Mapped Signals 1.5.2. Time-of-day Signals 1.5.3. Pulse-Per-Second Signals 1.5.4. Clocking Requirements
2. Time-of-day Synchronizer x
2.1. Release Information 2.2. Resource Utilization 2.3. Configuring the TOD Synchronizer 2.4. Using the TOD Synchronizer 2.5. Interface Signals
2.4. Using the TOD Synchronizer x
2.4.1. Sampling Clock Frequency
3. Packet Classifier x
3.1. Release Information 3.2. Resource Utilization 3.3. Configuring the Packet Classifier 3.4. Interface Signals
3.4. Interface Signals x
3.4.1. Clock and Reset Signals 3.4.2. Avalon® Streaming Interface Signals 3.4.3. Control Signals
1. Time-of-day Clock
2. Time-of-day Synchronizer
3. Packet Classifier
4. Ethernet Design Example Components User Guide Archives
5. Document Revision History for the Ethernet Design Example Components User Guide

2. Time-of-day Synchronizer

The Time-of-day (TOD) Synchronizer provides an accurate synchronization between the time of day of a master TOD clock and a target TOD clock. This component can synchronize the following combination of master and target TOD clocks:
  • Master and target TOD clocks that operate at the same frequency, between 125 MHz and 390.625 MHz. The synchronizer also supports different clock phases and PPM.
  • Master and target TOD clocks that operate at different frequencies: 62.5 MHz, 125 MHz, 156.25 MHz, 312.5 MHz, 390.625 MHz, or 402.83 MHz.

You can instantiate the TOD synchronizer through the Ethernet IEEE 1588 TOD Synchronizer Intel® FPGA IP in the Quartus® Prime software.


Section Content
Release Information
Resource Utilization
Configuring the TOD Synchronizer
Using the TOD Synchronizer
Interface Signals

Level Two Title