External Memory Interface Handbook Volume 1: Intel® FPGA Memory Solution Introduction and Design Flow: For UniPHY-based Device Families

Download PDF
ID 710283
Date 3/06/2023
Public
Document Table of Contents
Document Table of Contents x
1. Introduction to this Handbook 2. Recommended Design Flow 3. Selecting Your Memory 4. Selecting Your FPGA Device
1. Introduction to this Handbook x
1.1. Introduction to Memory Solutions 1.2. Protocol Support Matrix 1.3. Document Revision History
2. Recommended Design Flow x
2.1. Getting Started With External Memory Interfaces 2.2. Document Revision History
2.1. Getting Started With External Memory Interfaces x
2.1.1. Selecting Your External Memory Device 2.1.2. Selecting Your FPGA 2.1.3. Planning Your Pin Requirements 2.1.4. Planning Your FPGA Resources 2.1.5. Determining Your Board Layout 2.1.6. Specifying Parameters for Your External Memory Interface 2.1.7. Performing Functional Simulation 2.1.8. Adding Design Constraints 2.1.9. Compiling Your Design and Verifying Timing 2.1.10. Verifying and Debugging External Memory Interface Operation
3. Selecting Your Memory x
3.1. DDR SDRAM Features 3.2. DDR2 SDRAM Features 3.3. DDR3 SDRAM Features 3.4. QDR, QDR II, and QDR II+ SRAM Features 3.5. RLDRAM II and RLDRAM 3 Features 3.6. LPDDR2 Features 3.7. Memory Selection 3.8. Example of High-Speed Memory in Embedded Processor 3.9. Example of High-Speed Memory in Telecom 3.10. Document Revision History
4. Selecting Your FPGA Device x
4.1. Memory Standards 4.2. I/O Interfaces 4.3. Wraparound Interfaces 4.4. Read and Write Leveling 4.5. Dynamic OCT 4.6. Device Settings Selection 4.7. Document Revision History
4.6. Device Settings Selection x
4.6.1. Device Speed Grade 4.6.2. Device Operating Temperature 4.6.3. Device Package Size 4.6.4. Device Density and I/O Pin Counts
1. Introduction to this Handbook
2. Recommended Design Flow
3. Selecting Your Memory
4. Selecting Your FPGA Device

3.2. DDR2 SDRAM Features

DDR2 SDRAM is a 4n prefetch architecture (internally the memory operates at half the interface frequency) with two data transfers per clock cycle. DDR2 SDRAM can use a single-ended or differential strobe, DQS or DQSn, which is associated with a group of data pins, and DQ for read and write operations. The DQS, DQSn, and DQ are bidirectional ports. Address ports are shared for read and write operations.

DDR2 SDRAM includes additional features such as increased bandwidth due to higher clock speeds, improved signal integrity on DIMMs with on-die terminations, and lower supply voltages to reduce power.

Level Two Title