AN 509: Multiplexing SDIO Devices Using Altera MAX Series

Download PDF
ID 683683
Date 9/22/2014
Public
Document Table of Contents
Document Table of Contents x
1. Multiplexing SDIO Devices Using Altera MAX Series
1. Multiplexing SDIO Devices Using Altera MAX Series x
1.1. Using Multiple SD Devices 1.2. I2C Select Line Multiplexer Using MAX II Devices 1.3. Acknowledgments 1.4. Document Revision History
1.2. I2C Select Line Multiplexer Using MAX II Devices x
1.2.1. Design Demonstration on the MDN-B2 Demo Board 1.2.2. Setting up a Parallel Port Driven I2C Environment on PC 1.2.3. Setting up SD Host/Card Reader to Work with The MDN-B2 Demo Setup
1. Multiplexing SDIO Devices Using Altera MAX Series

1.2.1. Design Demonstration on the MDN-B2 Demo Board

To demonstrate this design on the MDN-B2 demo board, perform the following steps:

  1. Turn on the power to the demo board (using slide switch SW1).
  2. Download the design onto the MAX II device through the JTAG header JP5 on the demo board and a conventional programming cable (ByteBlaster™ II or USB-Blaster™).
  3. Keep SW4 on the demo board pressed before and during the start of the programming process.
  4. Once completed, turn off the power and remove the JTAG connector.
Level Two Title